Network LAN Technologies

Ethernet

Ethernet is a Local Area Network implemenation technology which is widely deployed. This technology was invented by Bob Metcalfe and D.R. Boggs in early 70s. It was standardized in IEEE 802.3 in 1980. Ethernet is network technology which shares media. Network which uses shared media has high probability of data collision. Ethernet uses CSMA/CD technology to detect collisions. CSMA/CD stands for Carrier Sense Multi Access/Collision Detection. When a collision happens in Ethernet, all its host rolls back and waits for some random amount of time and then re-transmit data.

Ethernet connector, i.e. Network Interface cards are equipped with 48-bits MAC address. This help other Ethernet devices to identify and communicate with remote devices in Ethernet.

Traditional Ethernet uses 10BASE-T specifications. 10 is for 10mpbs speed, BASE stands for using baseband and T stands for Thick net or Thick Ethernet. 10BASE-T Ethernet provides transmission speed up to 10mbps and uses Coaxial cable or Cat-5 Twisted Pair cable with RJ-5 connector. Ethernet follows Star Topology with segment length up to 100 meters. All devices are connected to a Hub/Switch in a Star Fashion.

Fast-Ethernet

To encompass need of fast emerging software and hardware technologies, Ethernet extends itself as Fast-Ethernet. It can run on UTP, Optical Fiber and can be wireless too. It can provide speed up to 100 mbps. This standard is named as 100BASE-T in IEEE 803.2 using Cat-5 Twisted pair cable. It uses CSMA/CD technique for wired media sharing among Ethernet hosts and CSMA/CA (Collision Avoidance) technique for wireless Ethernet LAN.

Fast Ethernet on fiber is defined under 100BASE-FX standard which provides speed up to 100mbps on fiber. Ethernet over Fiber can be extended up to 100 meters in half-duplex mode and can reach maximum of 2000 meters in full-duplex over multimode fibers.

Giga-Ethernet

After being introduced in 1995, Fast-Ethernet could enjoy its high speed status only for 3 years till Giga-Ethernet introduced. Giga-Ethernet provides speed up to 1000 mbits/seconds. IEEE802.3ab standardize Giga-Ethernet over UTP using Cat-5, Cat-5e and Cat-6 cables. IEEE802.3ah defines Giga-Ethernet over Fiber.

In above pictures, different VLANs are depicted in different color codes. Hosts in one VLAN, even if connected on the same Switch cannot see or speak to other hosts in different VLANs. VLAN is Layer-2 technology which works closely on Ethernet. To route packets between two different VLANs a Layer-3 device (such as Router) is required.